House lead-ins ADSB

For buildings with basement

• For direct use in concrete - to be applied without auxiliary materials.
• The ADSB is suitable for surroundings with non-pressing water.
• Each kit contains an inner and an outer part with integrated seals, for up to two speedpipe or cables into the house through the cellar.
• After the blowing-in process the speedpipe ground is fed into the integrated deflection pulley and lead along the cellar wall. 
• The ADSB and ADSB-D are available for various cable and speedpipe diameters.

For buildings with/without basement

• For direct use in concrete - to be applied without auxiliary material.
• The ADSB-F can also be installed in buildings without basement.
• Installation with an installation angle of up to 30°.

Accessories: Casing tube SKW

To ensure that the integrated seal of the ADSB, ADSB-D and ADSB-F house lead-ins can grip completely via the lever mechanism even with brickwork or a wall thickness of over 400 mm, the additional use of the sanded scabbard duct SKW is recommended.

Features

• Water impact classes according to DIN 18533:
  W1.1-E: Soil moisture and non-pressing water in floor slabs and walls in contact with the ground
  W1.2-E: Soil moisture and non-pressing water in floor slabs and walls in contact with the ground with drainage
• Gas and water tightness: 1 bar
• Principle of sealing: integrated sealing element
• installation in concrete wall: no auxiliary material needed
• installation in hollow block: casing tube

(From a wall thickness of 400 mm, the use of a casing tube is recommended.)