speed•pipe® bundle ground gabo Systemtechnik SRV-G und SRV-G tc Laying instructions 9 For cutting the speed•pipe® bundle or the speed•pipe® never use chip-producing tools like a saw. Separate the bundle by means of a pipe cutter. The internal speed•pipe® must be separated with a speed•pipe® cutter. Cutting a speed•pipe® for coupling it with a connector (DSM) must be carried out by a straight rectangular cut towards the pipe axis. Cut speed•pipe® that are not coupled with a connector (DSM) afterwards, must be sealed immediately against dirt and the penetration of water by means of a corresponding EZA-t or ES. Please consider the respective assembly instruction for installing the connector. speed•pipe® cutter and pipe cutter Note: Uncut speed•pipe® (without connector) are the optimal requirement for blowing in a micro cable. Therefore, try to make less cuts. Therefore, pull the SRV-G in one step if possible e. g. during passing a route of several crossings / courtyard entrances. 5. Cutting speed•pipe® / speed•pipe® bundle ground.
RkJQdWJsaXNoZXIy MTYzMjU=