gabo Systemtechnik speed•pipe® bundle ground Laying instructions SRV-G und SRV-G tc 34 The main advantage is that only one spool has to be handled in comparison with the installation of single ducts. By pulling into existing ducts smaller than 80 mm the coating pipe (outer jacket) of the bundle has to be removed by a cutting unit. Only SRV-G bundles with flexible coating pipes (loose outer jacket) can be used! For a maximum occupancy of existing ducts (Ø 32, Ø 40, Ø 50 and Ø 63) speed•pipe® ground can be pulled in from the SRV-G. The single speed•pipe® ground are pulled in with the help of a pulling head. The SRV jacket pipe, before reaching the duct is slit by means of a slicing device and recycled (PE-HD). The reachable pull in length is limited by the permissible tensile force of the speed•pipe® ground (see table). A positive effect can be achieved by rotating the coil and by using lubricants. The maximum number of speed•pipe® ground depends on the dimensions of the duct and a possible combination with larger speed•pipe® ground (see table). for duct speed•pipe® 7 x 1.5 + 1 speed•pipe® speed•pipe® 7 x 1.5 Ø 63 x 5.8 (4.7) Ø 40 x 3.7 (2.5) Ø 32 x 2.9 (2.0) Ø 50 x 4.6 (3.0) SRV-G 50 / 24 x7 max. recommended tensile force 6500 N SRV-G32/6x7 max. recommended tensile force 1800 N SRV-G 50 / 10 x7 max. recommended tensile force 3000 N SRV-G 40 / 14 x7 max. recommended tensile force 3900 N SRV-G 50 / 18 x7 max. recommended tensile force 5000 N SRV-G40/8x7 max. recommended tensile force 2400 N speed•pipe® 14 x 2.0 (12 x 2.0), max. recommended tensile force 800 N (700 N) SRV-G 50 / 10 x7 max. recommended tensile force 3000 N SRV-G 50 / 24 x7 max. recommended tensile force 6500 N speed•pipe® 16 x 2.0 (14 x 2.0), max. recommended tensile force 900 N (800 N) speed•pipe® 14 x 2.0 (12 x 2.0), max. recommended tensile force 800 N (700 N) 12.2 Pulling in speed•pipe® ground from the SRV-G into existing ducts (Ø 32 – 63 mm).
RkJQdWJsaXNoZXIy MTYzMjU=